Oxy-Acetylene Cutting Pressure Chart – Cutting data charts are intended as a guide for quality cutting. If you have a cylinder cart, place. Manufacturers recommended pressure settings for welding, cutting and heating for oxygen and acetylene oxygen and acetylene cutting plate thickness mm. The above data applies to all torches with the following exceptions:

The oxygen pressure typically ranges from 30 to 40 psi (pounds per. One standard size g acetylene cylinder (1/7 rule). Proper gas pressure settings are crucial for achieving clean and efficient cuts. Increase pressures if longer hose is used.

Oxy-Acetylene Cutting Pressure Chart

Oxy-Acetylene Cutting Pressure Chart

Cutting oxygen adjustment procedure set supply pressure for cutting oxygen pressure at supply regulator to approximately 90 psi adjust cutting oxygen pressure on hi/low. Tip size numbers vary among. *** all pressures are measured at the pressure regulator with a 3/8 inch, 25 feet long hose.

Tables show approximate gas pressures for welding or cutting. Then the cutting and gouging processes can begin to remove the metal. The data was gathered under ideal shop conditions and on new, clean steel.

When the steel becomes “cherry red”, the added oxygen. Pressures shown are for 25 ft (7.6 m) or less of 3/8 in. Size cutting oxy fuel thickness pressure pressure mm kpa kpa 6290 000 0.

Welding.xls oxygen & acetylene gas pressures welding cutting notes: Ensure never to exceed 15 psi for acetylene. Victor® mthp high speed machine cutting note:

Oxy Acetylene Cutting Pressure Chart

oxyacetylene regulator pressures?

Oxy Acetylene Cutting Pressure Chart

Oxy Acetylene Cutting Pressure Chart

Oxy Acetylene Cutting Pressure Chart

Cutting Torch Guide

oxyacetylene new tip Page 2

Oxy Acetylene Cutting Pressure Chart

Oxy Acetylene Pressure Settings Chart Best Picture Of Chart

Oxyacetylene Torch Settings Chart

What Determines The Oxygen And Acetylene Pressure That Must Be Used For

oxygen and acetylene pressure settings

OxyAcetylene Welding Tips Model W1 Compatible with 100 Series Victor

CNC OxyFuel Cutting Tables AKS Cutting Systems